Hot Dawg Frequently Asked QuestionsQ: What is a Hot Dawg? A: A low-profile gas-fired unit heater that is designed to heat garages and is certified for residential, commercial, and industrial use. Q: What type of fuel feeds the Hot Dawg ? A: The Hot Dawg unit heater can operate on either natural or propane gas. Q: Does the Hot Dawg vent to the outside of the garage? A: Yes, it is supplied with a factory-installed venting system that allows for either vertical or horizontal venting. Vent pipe must be purchased separately. Q: What size Hot Dawg is needed to heat my garage? A: The answer depends on many variables such as building construction, location, number of doors, etc. As a general guideline you can use the following table, but you may wish to have a qualified contractor perform a heat-loss calculation. Unit Btu/Hr Input Application HD30 30,000 1 to 1-1/2 Car Garage HD45 45,000 2 to 2-1/2 Car Garage HD60 60,000 3 to 3-1/2 Car Garage HD75 75,000 Large Garage,Commercial & Light Industrial Q: How big is the Hot Dawg? A: This information is found on the Hot Dawg Specification sheet or can be obtained by e-mail or calling our office. Q: Do I have to allow for space around the Hot Dawg? A: Yes, and this information is found on the Hot Dawg Specification sheet. or can be obtained by e-mail or calling our office. Q: What supply voltage is required? A: 115 volt, 60 hertz, single phase Q: What is the amp draw for the unit? A: This information is found on the Hot Dawg Specification sheet or can be obtained by e-mail or calling our office. Q: What size gas connection does the Hot Dawg have? A: The Hot Dawg has a ˝ gas connection. Q: What size vent pipe should I use? A: The unit utilizes either 3 or 5 vent pipe depending upon the application. Q: How is the Hot Dawg mounted in a garage? A: The Hot Dawg includes angled hanging brackets designed for 3/8 bolts, lag screws, or rods. This allows for snug-to-ceiling installation with 1 clearance, or the unit can be suspended with threaded rods. Q: Can I install the Hot Dawg myself? A: The unit requires gas, vent, and electrical connections. For this reason, we recommend that the unit be installed by a qualified installation and service contractor. Q: Can the unit be flipped to allow left-or-right hand access to the controls? A: Yes, the unit can be flipped. Q: Can the louvers be moved? A: Yes, the louvers are fully adjustable to direct heat where it is needed. Q: Is the Hot Dawg covered by a warranty? A: Yes, the residential warranty is two years on materials and workmanship on all parts except the heat exchanger, which is ten years on materials and workmanship. All information on this Web site is deemed reliable, but is not guaranteed. |
Email at: btgrowersupply@centurytel.net Copyright©2007 All Rights Reserved
|